SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 212 (ENGINE CONTROLS - 2.2L (L61) INTRODUCTION)REPAIR INSTRUCTIONSAIR CLEANER INTAKE DUCT REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the resonator assembly through the wheel house opening.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the resonator rear push-in retainer and the upper attaching bolt (5).

    Tighten:  Tighten the bolt to 7 N.m (61 lb in).

    Fig 1: View Of Air Cleaner Intake Duct
    GM13220Courtesy of GENERAL MOTORS CORP.
  3. Install the front air cleaner intake duct (3) through the headlamp assembly opening.
  4. Install the lower push-in retainer (4) to the front air cleaner intake duct.
  5. Install the left front wheel house panel. Refer to Front Fender Liner Replacement in Body Front End.
  6. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  7. Lower the vehicle.
  8. Install the upper push-in retainer (1) to the front air cleaner intake duct.
  9. Install the headlamp assembly. Refer to Headlamp Assembly or Headlamp Bulb Replacement (Pontiac) in Lighting Systems.
  10. Install the air cleaner outlet splash shield.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.