Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data Definitions
- Cruise Control Active
-
Displays Yes or No. The status of the cruise engaged signal. The cruise control module grounds the circuit when cruise control is on.
- Cruise Release Clutch/TCC Pedal Switches
-
Displays Applied or Released. The status of the cruise release signal circuit. The TCC/brake pedal switch and the clutch pedal position (CPP) switch if equipped, are normally closed switches, in series, controlling the cruise control cancel circuit.
- Vehicle Speed Sensor
-
Displays km/h and mph. The vehicle speed sensor signal is converted into km/h and mph for display.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.