Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Enabling Procedure
2001 Chevrolet Cavalier LS, 2.4 TSECTION Enabling Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the key from the ignition switch.
- Connect the side impact module - LF connector located under the driver seat.
- Install the CPA to the inflatable restraint side impact module - LF connector (1).
- Install the AIR BAG fuse to the LH I/P wiring harness junction block.
- Install the LH I/P outer trim cover. Refer to Instrument Panel (I/P) Outer Trim Cover Replacement (Chevrolet) or Instrument Panel (I/P) Outer Trim Cover Replacement (Pontiac) in Instrument Panel, Gages, and Console.
- Staying well away from both air bags, turn ON the ignition.
- The AIR BAG indicator will flash 7 times.
- The AIR BAG indicator will then turn OFF.
- Perform Diagnostic System Check - SIR if the AIR BAG indicator does not operate as described.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.