SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 206 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSCOAXIAL CABLE REPLACEMENT - DIGITAL RADIOINSTALLATION PROCEDURE
2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the replacement coaxial cable (4) along side the old coaxial cable harness. Secure the new coaxial cable to the old coaxial harness every 150 mm (6 in) with electrical tape, nylon straps, or a hot glue gun.
    Fig 1: Aligning Coaxial Cable- Digital Radio
    GM885693Courtesy of GENERAL MOTORS CORP.
  2. Connect the coaxial cable to the pigtail connector (2) at the antenna base.
  3. Install the headliner (8) to the original position. Refer to Headliner Replacement in Interior Trim.
  4. Install the coax cable connector (5) to the digital radio receiver.
  5. Install the rear window trim panel. Refer to Trim Panel Replacement - Rear Window Shelf in Interior Trim.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.