Scan Tool Output Controls

2001 Chevrolet Cavalier LS, 2.4 TSECTION Scan Tool Output Controls
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
Radio Scan Tool Output Control

Scan Tool Output Control Additional Menu Selections Description
Chime Tone 1 Chime Tone Test Commanding the test ON will generate a 750 Hz tone that is audible from all speakers capable of generating this frequency.
Commanding the test OFF will exit the test. The audio system will resume normal operation.
Chime Tone 2 Chime Tone Test Commanding the test ON will generate a 2 kHz tone that is audible from all speakers capable of generating this frequency.
Commanding the test OFF will exit the test. The audio system will resume normal operation.
Chime Tone 3 Chime Tone Test Commanding the test ON will generate a 10 kHz tone that is audible from all speakers capable of generating this frequency.
Commanding the test OFF will exit the test. The audio system will resume normal operation.
Left Front Speaker Front Speakers Commanding the speaker ON will turn off all speakers except this speaker.
Commanding one speaker OFF will turn off all speakers.
Left Rear Speaker Rear Speakers Commanding the speaker ON will turn off all speakers except this speaker.
Commanding one speaker OFF will turn off all speakers.
Right Front Speaker Front Speakers Commanding the speaker ON will turn off all speakers except this speaker.
Commanding one speaker OFF will turn off all speakers.
Right Rear Speaker Rear Speakers Commanding the speaker ON will turn off all speakers except this speaker.
Commanding one speaker OFF will turn off all speakers.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.