Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Raise the window to the full UP position.
- Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door (Pontiac) or Trim Panel Replacement - Side Front Door (Chevrolet) .
- Remove the inside handle rivet.
- Slide the inside handle rearward in order to disengage the tabs.
- Remove both rods from the inside door handle. The rods are identified by the following colors:
- The left hand rod (3) is red.
- The right hand rod (2) is green.
- Remove the door water deflector in order access the door lock assembly. Refer to Water Deflector Replacement - Front Door .
- Remove the door lock assembly. Refer to Lock Replacement - Front Door .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.