SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 201 (WIRING SYSTEMS - SPECIFICATIONS, COMPONENT VIEWS AND CONNECTOR END VIEWS)COMPONENT LOCATORINLINE HARNESS CONNECTORSC102
2001 Chevrolet Cavalier LS, 2.4 T

Inline Harness Connectors: C102

2001 Chevrolet Cavalier LS, 2.4 TSECTION C102
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
C102 Engine To Fuel Injectors Connector End View

GM646400Courtesy of GENERAL MOTORS CORP.
GM684916Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 15326835
  • 8-Way F GT 150 Sealed 4.0 (BLK)
 Connector Part Information
  • 15326840
  • 8-Way M GT 150 Sealed 4.0 (BLK)
Pin Wire Color Circuit No. Function Pin Wire Color Circuit No. Function
A BLK 1744 Fuel Injector 1 Control A BLK 1744 Fuel Injector 1 Control
B LT GRN/BLK 1745 Fuel Injector 2 Control B LT GRN/BLK 1745 Fuel Injector 2 Control
C PNK/BLK 1746 Fuel Injector 3 Control C PNK/BLK 1746 Fuel Injector 3 Control
D LT BLU/BLK 844 Fuel Injector 4 Control D LT BLU/BLK 844 Fuel Injector 4 Control
E PNK 839 Ignition 1 Voltage E PNK 839 Ignition 1 Voltage
F ORN/BLK 469 Low Reference F ORN/BLK 469 Low Reference
G LT GRN 432 MAP Sensor Signal G LT GRN 432 MAP Sensor Signal
H GRY 2704 5-Volt Reference H GRY 2704 5-Volt Reference
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.