Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2 (POWER MIRROR SYSTEM)DIAGNOSTIC TESTSDTC B2224: RIGHT MIRROR SELECT SWITCH FAULT
2001 Chevrolet Cavalier LS, 2.4 T
DTC B2224: Right Mirror Select Switch Fault
2001 Chevrolet Cavalier LS, 2.4 TSECTION DTC B2224: Right Mirror Select Switch Fault
WARNING: This page is about a different car, the 2000 Chevrolet Corvette, 1999 Chevrolet Corvette, and 1998 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Perform DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM. Go to next step.
- Using scan tool, select LDCM input and observe passenger mirror select switch status. If scan tool displays ACTIVE, leave scan tool connected and go to next step. If scan tool displays INACTIVE, problem is intermittent. Check left-side mirror select switch circuit wiring and connections. See WIRING DIAGRAMS . If left-side mirror select switch circuit checks okay, retest system. If DTC B2224 sets as a history code, go to step 5 .
- Disconnect left door switch connector. With LDCM input selected, observe passenger mirror select switch status. If scan tool displays ACTIVE, go to next step. If scan tool displays INACTIVE, replace power mirror switch. See POWER MIRROR SWITCH under REMOVAL & INSTALLATION.
- Check for short to ground in Light Blue/White wire between Left Door Control Module (LDCM) connector C4 terminal No. 2 and left door switch connector terminal No. 2. See Figure . See WIRING DIAGRAMS . If Light Blue/White wire is okay, go to next step.
- Replace LDCM. See DOOR CONTROL MODULE under REMOVAL & INSTALLATION.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.