SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 193 (INTERIOR TRIM)REPAIR INSTRUCTIONSTRIM REPLACEMENT - LOCK PILLAR (UPPER CONVERTIBLE)INSTALLATION PROCEDURE
2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the lock pillar upper trim.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the screw securing the upper trim to the lock pillar.

    Tighten 

    Tighten the lock pillar upper trim screw to 1.8 N.m (16 lb in).

  3. Install the spacer and washer to the seat belt guide stud.
    Fig 1: Upper Trim
    G01451769Courtesy of GENERAL MOTORS CORP.
  4. Install the upper seat belt guide.

    Tighten 

    Tighten the upper guide nut to 40 N.m (29 lb ft).

    Fig 2: Installing Seatbelt Upper Guide To Stud
    G01451770Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.