Removal Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Important:Β  To reduce the chance of damage to the trim panel leave the switch in the panel until after the panel is removed from the door.

  1. Lower the door window.
  2. Remove the inside handle bezel. Refer to HANDLE BEZEL REPLACEMENT - INSIDEΒ .
    Fig 1: Inside Handle Bezel
    G01451135Courtesy of GENERAL MOTORS CORP.
  3. Remove the pull handle plug.
    Fig 2: Pull Handle Plug
    G01451136Courtesy of GENERAL MOTORS CORP.
  4. Remove the screws behind the pull handle plug.
    Fig 3: Removing Screws Behind Pull Handle Plug
    G01451137Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.