SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 189 (BODY FRONT END)REPAIR INSTRUCTIONSHOOD REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the aid of a helper position the hood with hinges relative to the marks on the frame rails.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the nuts attaching the hinge to the frame rail.

    Tighten 

    Tighten the hinge to frame rail nuts to 25 N.m (18 lb ft).

    Fig 1: Installing Nuts Attaching Hinge To Frame Rail
    G01450961Courtesy of GENERAL MOTORS CORP.
  3. Install the struts.
    Fig 2: Struts
    G01450962Courtesy of GENERAL MOTORS CORP.
  4. Connect the under hood light electrical connection.
  5. Adjust the hood fit as necessary.
    Fig 3: Connecting Under Hood Light Electrical Connection
    G01450963Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.