Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 189 (BODY FRONT END)REPAIR INSTRUCTIONSHOOD LATCH RELEASE CABLE REPLACEMENTINSTALLATION PROCEDURE

2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Route the cables through the opening in the dash panel, past the retainers (1) on the plenum panel, to the latches.

Fig 1: Release Cable
Courtesy of GENERAL MOTORS CORP.
Position the latch handle.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the screws which mount the hood release handle.
Tighten

Tighten the screws to 2 N.m (18 lb in).

Fig 2: Hood Release Handle
Courtesy of GENERAL MOTORS CORP.
Install the cable grommet through the slits in the carpet insulator and into the dash panel.

Fig 3: Cable Grommet
Courtesy of GENERAL MOTORS CORP.
Connect the cables to the latches.
Install the hood latches. Refer to HOOD LATCH REPLACEMENT - LEFT and to HOOD LATCH REPLACEMENT - RIGHT .

Fig 4: Hood Latches
Courtesy of GENERAL MOTORS CORP.
Install the cable to the retainers (1).
Verify the operation of the latches.

Fig 5: Installing Cable To Retainers
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.