Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 187 (STATIONARY WINDOW SYSTEM)REPAIR INSTRUCTIONSREARVIEW MIRROR REPLACEMENT (DD8)INSTALLATION PROCEDURE

2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Install the electrical connector (1) to the back of the inside rearview mirror.

Fig 1: Installing Electrical Connector To Back Of Inside Rearview Mirror
Courtesy of GENERAL MOTORS CORP.
Perform the following steps to install the inside rearview mirror:
1. Center the bottom of the inside rearview mirror on the support.
  Important: Do NOT pull rearward on the mirror while installing the mirror or damage to the support and/or windshield will occur.
2. Rock the inside rearview mirror from side to side while pushing downward firmly. Take care not to damage the windshield.
3. An audible click is heard when the inside rearview mirror is fully seated.
Fig 2: Inside Rearview Mirror
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.