Removal Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and position the convertible top with the 1 and 5 bows upright.
  2. Raise or leave raised, the folding top stowage compartment lid.
    Fig 1: Raising & Positioning Convertible Top With 1 & 5 Bows Upright
    G01453656Courtesy of GENERAL MOTORS CORP.
  3. Remove the push-in fastener from the rear compartment side trim panel.
  4. Remove the rear compartment side trim panel.
    Fig 2: Rear Compartment Side Trim Panel
    G01453657Courtesy of GENERAL MOTORS CORP.
  5. Remove the rear speaker retaining screws.
  6. Begin to remove the rear speaker in order to access the electrical/audio connector.
  7. Disconnect the electrical/audio connector from the rear speaker.
  8. Remove the rear speaker.
    Fig 3: Rear Speaker
    G01453658Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.