Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical/audio connector to the rear speaker.
  2. Install the rear speaker into position.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the rear speaker retaining screws.

    TightenΒ 

    Tighten the rear speaker retaining screws to 2.5 N.m (22 lb in).

    Fig 1: Rear Speaker
    G01453659Courtesy of GENERAL MOTORS CORP.
  4. Install the rear compartment side trim panel.
  5. Install the push-in fastener to the rear compartment side trim panel.
  6. Lower the folding top stowage compartment lid.
  7. Raise the convertible top.
    Fig 2: Rear Compartment Side Trim Panel
    G01453660Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.