SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 177 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSFOG LAMP REPLACEMENT - REARINSTALLATION PROCEDURE
2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rear fog lamp assembly to the rear fascia.
  2. Install the bezel to the lamp.

    Insert the bezel into the slot on the lamp, then pivot the bezel onto the stud.

    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the rear fog lamp bezel retaining nut.

    Tighten 

    Tighten the rear fog lamp bezel retaining nut to 2 N.m (18 lb in).

    Fig 1: Rear Fog Lamp Bezel Retaining Nut
    G01453353Courtesy of GENERAL MOTORS CORP.
  4. Install the socket to the lamp.
  5. Install the tail/turn signal lamp. Refer to TAIL/TURN SIGNAL LAMP REPLACEMENT (EUROPE, JAPAN) .
    Fig 2: Installing Socket To Lamp
    G01453354Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.