Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Release and lift the windshield defroster grille from the I/P upper trim pad.
- Insert two small flat bladed screwdrivers, or other suitable tools, close to each other between the rear edge of the defroster grille and the upper trim pad near one corner of the grille.
- Begin to CAREFULLY pry the grille up from the trim pad.
- Work the screwdrivers gradually to the other corner of the grille while continuing to CAREFULLY pry the grille up.
- Lift the grille to access the DRL sensor.
- Twist to release the DRL sensor from the grille.
- Disconnect the electrical connector from the sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.