SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 169 (ENGINE COOLING SYSTEM)REPAIR INSTRUCTIONSFAN SHROUD REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fan shroud.
  2. Raise the vehicle.
    Fig 1: Fan Shroud
    G01971802Courtesy of GENERAL MOTORS CORP.
  3. Install the radiator outlet hose to the radiator.
  4. Reposition the radiator outlet hose clamp to the radiator using J 38185  .
    Fig 2: Installing Radiator Outlet Hose To Radiator
    G01971803Courtesy of GENERAL MOTORS CORP.
  5. Install the forward lamp harness to the retaining clips on the fan shroud.
  6. Connect the cooling fan electrical connectors.
    Fig 3: Connecting Cooling Fan Electrical Connectors
    G01971804Courtesy of GENERAL MOTORS CORP.
  7. Lower the vehicle.
  8. Install the radiator inlet hose to the radiator.
  9. Reposition the radiator inlet hose clamp to the radiator using J 38185  .
  10. Install the radiator support. Refer to RADIATOR SUPPORT REPLACEMENT .
  11. Fill the cooling system. Refer to DRAINING AND FILLING COOLING SYSTEM .
    Fig 4: Installing Radiator Inlet Hose To Radiator
    G01971805Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.