Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the crankshaft balancer. Refer to CRANKSHAFT BALANCER REPLACEMENT .
- Remove the water pump. Refer to WATER PUMP REPLACEMENT in Engine Cooling.
- Remove the oil pan-to-front cover bolts (2).
- Remove the front cover bolts.
- Remove the front cover and gasket.
- Discard the front cover gasket.
- Clean and inspect the engine front cover. Refer to ENGINE FRONT COVER CLEANING AND INSPECTION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.