Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Install the driveline tunnel closeout panel into position.
- Install the bolt into the closeout panel locating hole (1).
- Install the bolt into the closeout panel slotted hole (2)NOTE: Refer to FASTENER NOTICE .
Important: ALL of the driveline tunnel closeout panel bolts must be installed and torqued to specifications, the closeout panel functions as a part of the vehicle body structure.
- Install the remaining bolts.
Tighten
Tighten the driveline tunnel closeout panel bolts to 10 N.m (89 lb in).
- Install the catalytic converters. Refer to CATALYTIC CONVERTER REPLACEMENT in Engine Exhaust.
- Lower the vehicle.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.