Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 164 (TIRE PRESSURE MONITORING SYSTEM)REPAIR INSTRUCTIONSTIRE PRESSURE SENSOR WASHER REPLACEMENTREMOVAL PROCEDURE
2001 Chevrolet Cavalier LS, 2.4 T
Removal Procedure
2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Raise the vehicle on a suitable support. Refer to LIFTING AND JACKING THE VEHICLE .
- Remove the tire/wheel assembly from the vehicle. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
- Remove the tire from the wheel. Refer to TIRE MOUNTING AND DISMOUNTING in Tires and Wheels.
- Remove the tire pressure sensor nut.
- Remove the tire pressure sensor.
- Remove the washer from the tire pressure sensor.
IMPORTANT:
Care must be given in the following areas to ensure the sensor is not damaged upon sensor installation and tire mounting.
- Position the new sensor with the air passage facing away from the wheel
- When torquing the sensor nut ensure the sensor body stays parallel to the inside wheel surface and does not rotate and contact the wheel.
- When mounting the tire back on the wheel ensure a tolerance is maintained between the tire machine, or irons, tire bead and the sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.