SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 159 (STEERING WHEEL AND STEERING COLUMN)REPAIR INSTRUCTIONSTELESCOPE MOTOR ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the telescope drive bracket (5) to the jacket assembly.
    Fig 1: Locating Telescope Drive Bracket Components
    G01419257Courtesy of GENERAL MOTORS CORP.
  2. Install the pan head tapping screw (3) to the telescope drive bracket (5).
    NOTE: Refer to FASTENER NOTICE .
  3. Install the guide retainer bolts.

    Tighten 

    Tighten the screw to 7 N.m (62 lb in).

  4. Install the telescope drive motor assembly (2) to the telescope drive bracket (5).
  5. Install the 2 pan head tapping screws (4) to the telescope drive bracket (5).

    Tighten 

    Tighten the screws to 7 N.m (62 lb in).

  6. Install the connector clip (1) to the telescope drive motor assembly connector (2).
    CAUTION: Refer to SIR INFLATOR MODULE COIL CAUTION .
  7. Connect the cable assembly (2) to the telescope drive motor assembly connector (1).
    Fig 2: Connecting Cable Assembly To Telescope Drive Motor Assembly Connector
    G01419258Courtesy of GENERAL MOTORS CORP.
  8. Remove the steering column from J 41352. 
  9. Install the steering column. Refer to STEERING COLUMN REPLACEMENT  .
  10. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.