Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the following components to the strut:
    Fig 1: Identifying Strut Components
    G01580075Courtesy of GENERAL MOTORS CORP.
    1. 1.1. The lower insulator (9)
    2. 1.2. The spring bumper (7)
    3. 1.3. The coil spring (10)
    4. 1.4. The upper insulator (6)
    5. 1.5. The spring seat (5)
    6. 1.6. The dust seal (4)
    7. 1.7. The strut support (3)
  2. Mount the strut assembly into the J 34013-B using the J 34013-88.Β 
    Fig 2: Identifying Strut Spring Compressor Special Tools
    G01580076Courtesy of GENERAL MOTORS CORP.
  3. Compress the coil spring (10).
    Fig 3: Identifying Strut Components
    G01580077Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.