Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 150 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSTEERING KNUCKLE REPLACEMENTINSTALLATION PROCEDURE

2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Install the steering knuckle (4) to the vehicle.

Fig 1: Identifying Strut Assembly-To-Steering Knuckle Nuts & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the lower ball joint to the steering knuckle. Refer to Lower Ball Joint Replacement .
NOTE: Refer to FASTENER NOTICE .
Install the bolts (3) and the nuts (6) attaching the steering knuckle (4) to the strut (2). Tighten the nuts (6) to 180 N.m (133 lb ft).
Install the hub and bearing assembly. Refer to Wheel Bearing/Hub Replacement - Front .
If the vehicle is equipped with ABS, connect the ABS electrical connector.
Install the tie rod to the steering knuckle. Refer to TIE ROD END REPLACEMENT - OUTER .
Install the tire and wheel assemblies. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
Inspect the front wheel alignment. Refer to MEASURING WHEEL ALIGNMENT .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.