Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the hood.
  2. Disconnect the battery ground (negative) cable.
  3. Install the J 28467-BΒ  J 28467-7A (1) and J 28467-B (2) to the vehicle.
    Fig 1: Engine Support Fixture
    G01777072Courtesy of GENERAL MOTORS CORP.
  4. Install the radiator shelf tube J 28467-2A (1).
    Fig 2: Radiator Shelf Tube J 28467-2A
    G01777073Courtesy of GENERAL MOTORS CORP.
  5. Install the J 28467-7 lift hook (1) to the front engine lift bracket
    Fig 3: Lift Hook To Front Engine Lift Bracket
    G01777074Courtesy of GENERAL MOTORS CORP.
  6. Install the J 28467-8 lift hook (1) to the rear engine lift bracket
    Fig 4: Lift Hook To Rear Engine Lift Bracket
    G01777075Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.