Engine Block Disassemble

2001 Chevrolet Cavalier LS, 2.4 TSECTION Engine Block Disassemble
WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the water jacket drain plug.
  2. Remove the oil flow check valve.
  3. Remove the oil passage plug.
  4. Remove the rear oil passage plug.
    Fig 1: Rear Oil Passage Plug
    G01777331Courtesy of GENERAL MOTORS CORP.
  5. Remove the knock sensor and bolt.
    Fig 2: Knock Sensor
    G01777332Courtesy of GENERAL MOTORS CORP.
  6. Remove the oil pressure switch.
    Fig 3: Oil Pressure Switch
    G01777333Courtesy of GENERAL MOTORS CORP.
  7. Remove the crankshaft position sensor and bolt.
    Fig 4: Crankshaft Position Sensor
    G01777334Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.