Removal Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly.
  3. Scribe the strut to the knuckle. See STRUT AND KNUCKLE SCRIBING under ADJUSTMENTS & INSPECTION in FRONT SUSPENSION article.
  4. Remove the strut mount to body nut (1) in the trunk area.
  5. Remove the strut bolts (3) from inside the fender well.
    Fig 1: Removing Strut Mount From Body
    G01583132Courtesy of GENERAL MOTORS CORP.
  6. Remove the strut knuckle bolts (5) and nuts (3) from the strut (1).
  7. Remove the strut (1) from the vehicle.
    Fig 2: Removing Strut From Vehicle.
    G01583133Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.