Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Aids
If DTC does not reset after code is cleared, problem may be intermittent. While performing tests, move wires and connectors. Following conditions may also cause an intermittent malfunction:
- Intermittent open or short to ground in Purple wire circuit between driver's door switch assembly and LDCM.
- Memory No. 2 switch is shorted to ground internally or is sticking.
- Memory No. 2 switch was depressed for longer than 20 seconds.
If Purple wire is shorted to ground or memory No. 2 switch is stuck closed, memory No. 2 selected features will operate but memory No. 1 functions will be inoperative.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.