Torque Specifications

2001 Chevrolet Cavalier LS, 2.4 TSECTION Torque Specifications
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Axle Shaft Nut 148 (200)
Ball Joint Nut
First Tightening Pass 41-50 (55-65)
Final Tightening Pass (1)
Control Arm Lower Mounting Bolts
Front 79 (107)
Rear 125 (170)
New Prevailing Torque Nut To Outer Tie Rod Ball Stud 33 (45)
Outer Tie Rod End Nut 33 (45)
Seal Retaining Clamp 130 (176)
Small Seal Retaining Clamp 100 (136)
Stabilizer Link To The Stabilizer Link Bolt 13 (17)
Wheel Lug Nuts 100 (140)
(1) Turn an additional 180Β°.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.