Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 116 (DISC BRAKES)SYSTEM TESTSBRAKE SYSTEM VACUUM SOURCE TEST
2001 Chevrolet Cavalier LS, 2.4 T
Brake System Vacuum Source Test
2001 Chevrolet Cavalier LS, 2.4 TSECTION Brake System Vacuum Source Test
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the engine vacuum hose from the vacuum brake booster check valve.
- Install a vacuum gage to the engine vacuum hose.
- Start the engine and allow the engine to idle until normal operating temperatures are reached.
- Check to see if the engine vacuum reading is within the specified normal engine vacuum range of 14-20 in. Hg (47-68 kPa).
- Turn the ignition OFF.
- If the engine vacuum reading is within the specified normal range, proceed to step 10.
- If the engine vacuum reading is NOT within the specified normal range, inspect the engine vacuum hose for tight connection to the engine, collapse, deformation or contamination, cracks, cuts and dry-rot.
- If any of these conditions were found with the engine vacuum hose, replace the hose, then repeat steps 2- 4.
- If none of these conditions were found with the engine vacuum hose, then there is an engine vacuum source problem, check the engine vacuum system.
- Remove the vacuum brake booster check valve from the booster.
- Install the check valve to the engine vacuum hose.
- Install the vacuum gage to the check valve.
- Start the engine and allow the engine to idle until normal operating temperatures are reached.
- Turn the ignition OFF.
- Check to see if the engine vacuum reading is maintained within the specified normal engine vacuum range. Specification 14-20 in. Hg (47-68 kPa).
- If the engine vacuum reading is maintained within the specified normal range, proceed to step 18.
- If the engine vacuum reading is NOT maintained within the specified normal range, replace the brake booster check valve, then repeat steps 11- 15.
- Inspect the brake booster check valve grommet for a firm connection to the vacuum brake booster, deformation or contamination, cracks, cuts and dry-rot.
- If any of these conditions were found with the check valve grommet, replace the grommet.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.