Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 104 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)DISABLING & ACTIVATING AIR BAG SYSTEMDISABLING SYSTEMZONE 9
2001 Chevrolet Cavalier LS, 2.4 T
Zone 9
2001 Chevrolet Cavalier LS, 2.4 TSECTION Zone 9
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Turn steering wheel to place vehicle wheels in straight-ahead position. Turn ignition off and remove key.
- Remove access panel from end of driver-side instrument panel. Remove AIR BAG fuse (15-amp) from instrument panel fuse block.
- To disable passenger side impact air bag module, go to step 7. To disable entire SIR system, complete remaining steps.
- Remove Connector Position Assurance (CPA) clip from driver-side air bag module connector and disconnect connector. See Figure.
- Remove CPA clip from passenger-side air bag module and disconnect connector. See Figure.
- Remove CPA clip from driver side impact air bag module and disconnect connector. See Figure.
- Remove Connector Position Assurance (CPA) clip from passenger side impact air bag module and disconnect connector. See Figure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.