Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Wash Mode
In WASH mode, voltage is applied to the following circuits:
- Windshield wiper switch on signal.
- Windshield washer pump control.
Windshield washer pump sprays washer solvent onto windshield. Windshield wipers operate at low or high speed for 3-5 wipes and return to the park position. If the wipers are in DELAY, "1" (LO), or "2" (HI) modes, wipers will return to that operation after wash cycle.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.