Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAB & CHASSIS SILVERADO 2D PICKUP, 8.1 G, 4WD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALWIRING SYSTEMS - COMPONENT LOCATOR - ELECTRICAL CENTER IDENTIFICATION VIEWSELECTRICAL CENTER IDENTIFICATION VIEWSFUSE BLOCK - CONNECTOR END VIEWSFUSE BLOCK C4
2001 Chevrolet Cab & Chassis Silverado 2D Pickup, 8.1 G, 4WD, Automatic
Fuse Block C4
2001 Chevrolet Cab & Chassis Silverado 2D Pickup, 8.1 G, 4WD, AutomaticSECTION Fuse Block C4
Fuse Block C4
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | LT BLU | 195 | Door Lock Control |
| B | WHT | 156 | Courtesy Lamp Low Control |
| C | DK BLU | 1307 | Power Window Master Switch Lockout Signal (Uplevel) |
| TAN | 201 | Left Front Speaker Output (+) (Base) | |
| D | WHT | 194 | Door Unlock Control |
| E | TAN | 126 | Left Front Door Open Switch Signal |
| F | GRY | 295 | Door Lock Motor Lock |
| G | BRN | 541 | Ignition 3 Voltage |
| H | BRN | 2409 | Interior Park Lamps Supply Voltage |
| J | ORN/BLK | 1732 | Courtesy Lamps Supply Voltage (Uplevel ) |
| GRY | 118 | Left Front Speaker Output (-) (Base Pickup) | |
| K | DK GRN | 1001 | RAP 1 Fuse Supply Voltage |
| BLK | 1850 | Ground (Base Pickup Only) | |
| L | ORN | 2140 | Battery Positive Voltage |
| M | TAN | 694 | Driver Door Lock Motor Unlock |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.