Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAB & CHASSIS SILVERADO 2D PICKUP, 8.1 G, 4WD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESBODY CONTROL MODULESREPAIR INSTRUCTIONSBODY CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet Cab & Chassis Silverado 2D Pickup, 8.1 G, 4WD, Automatic
Installation Procedure
2001 Chevrolet Cab & Chassis Silverado 2D Pickup, 8.1 G, 4WD, AutomaticSECTION Installation Procedure
- Slide the BCM onto the bracket.
- Connect all the connectors (1) except the brown connector.
- Connect the brown connector.
- Install the knee bolster. Refer to Knee Bolster Replacement (Luxury) , Knee Bolster Replacement (Non-Luxury) .
- Connect the negative battery cable(s).
- Reprogram the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.