Installation Procedure

2001 Chevrolet C3500 HD 8.1 G, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2001 GMC Sierra and 2001 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Hoses/Pipes (Canister/Fuel Tank)
    GM396067Courtesy of GENERAL MOTORS COMPANY
  1. Remove the caps from the fuel pipes.
  2. Connect the rear fuel feed pipe (4) and the rear fuel return pipe (5) to the fuel sender (2) and the fuel tank clips (6).
  3. Fig 2: View Of Fuel Tank & Straps
    GM300138Courtesy of GENERAL MOTORS COMPANY
  4. Install the fuel tank. Refer to Fuel Tank Replacement (Pickup)Β .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.