Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Low-Reverse Servo Assembly: Installation
Install the low-reverse band servo and cover. See Fig 1. Install and tighten the bolts to specification. See TORQUE SPECIFICATIONS . Install the oil feed pipe. See OIL FEED PIPES . Install the filter and oil pan. See DRAINING & REFILLING under LUBRICATION. Lower the vehicle. Connect the negative battery cable. Fill transaxle with appropriate fluid to proper level. See LUBRICATION .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
