2000 Chevrolet Malibu BaseFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Front Mount Bolt 96 (130)
Front Mount Lower Bolt 89 (120)
Front Mount Through-Bolt 55 (75)
Oil Cooler Pipe Fitting 33 (45)
PNP Switch Mounting Bolt 18 (24)
Side Mount Bolt 41 (56)
Side Mount Through-Bolt 41 (56)
Transaxle Mount Support Bolt 55 (75)
Transaxle-To-Body Bolt 49 (66)
INCH Lbs. (N.m)Β 
Intermediate-4th Servo Cover Bolt 106 (12)
Low-Rerverse Servo Cover Bolt 106 (12)
Oil Cooler Clip Bolt 27 (3)
Oil Feed Pipe Bolt 106 (12)
Oil Pan Bolt 124 (14)
Shift Cable Grommet Bolt 17 (2)
T.V. Cable Bolt 80 (9)
VSS Stud 97 (11)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.