Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000EXPRESS 3/4 TON VAN V8-5.7L VIN RREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIROVERHAULREPAIR INSTRUCTIONS81. TRANSMISSION OIL PAN INSTALLATION
2000 Chevrolet Express 3/4 Ton Van V8-5.7L VIN R
81. Transmission Oil Pan Installation
2000 Chevrolet Express 3/4 Ton Van V8-5.7L VIN RSECTION 81. Transmission Oil Pan Installation
1. Place the transmission oil pan gasket (73) on the case.
2. Place the transmission oil pan (75) on the case.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install all of the transmission oil pan screws (76).
^ Tighten the screws to 12 Nm (9 ft. lbs.).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.