Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000CHEVY EXPRESS G3500, VAN CARGO, 4.3 WREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONCOMPUTER RELEARN PROCEDURESRELEARN PROCEDURES (CARS)CAVALIER & SUNFIREELECTRONICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) PROGRAMMING
2000 Chevrolet Chevy Express G3500, Van Cargo, 4.3 W
Electronically Erasable Programmable Read Only Memory (EEPROM) Programming
2000 Chevrolet Chevy Express G3500, Van Cargo, 4.3 WSECTION Electronically Erasable Programmable Read Only Memory (EEPROM) Programming
- If Powertrain Control Module (PCM) was replaced, the EEPROM in the PCM must be programmed. If EEPROM is not programmed, a Diagnostic Trouble Code (DTC) will be set in the PCM or PCM may be damaged. Perform EEPROM programming using the Techline equipment manufacturer's instructions and latest software applicable for the vehicle model.
- Once EEPROM is reprogrammed, the Crankshaft Position (CKP) sensor variation learn procedure must be performed using proper procedure. See CRANKSHAFT POSITION (CKP) SENSOR VARIATION LEARN PROCEDURE.
NOTE:
Password must be learned when Passlock(TM) sensor, BCM or PCM is replaced. BCM must be programmed with proper RPO configurations before performing relearn procedures. If PCM is replaced, after programming, PCM will immediately learn the first password it receives. If password needs to be changed, learn procedure will need to be performed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.