Component Locations 2.2L (VIN 4) "S" Series

2000 Chevrolet Chevy Express G3500, Van Cargo Extended, 6.5 FSECTION Component Locations 2.2L (VIN 4) "S" Series
COMPONENT LOCATIONS 2.2L (VIN 4) "S" SERIES

Component Location
A/C Compressor Clutch Relay In Underhood Fuse/Relay Block
A/C Refrigerant Pressure Sensor On A/C Evaporator Tube
Air Pump Lower Right Side Of Engine Compartment
Body Control Module (BCM) Below Right Side Of Instrument Panel, On Heater
Camshaft Position (CMP) Sensor Right Side Of Engine, Forward Of Coil Packs
Crankshaft Position (CKP) Sensor Right Side Of Engine, Below Coil Packs
Cruise Control Module Left Rear Of Engine Compartment, On Cowl
Data Link Connector (DLC) Lower Left Side Of Instrument Panel
Engine Coolant Temperature (ECT) Sensor Front Of Engine, In Coolant Piping
EVAP Canister Purge Solenoid Right Side Of Engine, Above Coil Packs
EVAP Canister Vent Solenoid Crossmember Area Of Fuel Tank
Fuel Injectors On Lower Manifold Assembly
Fuel Pump Relay In Underhood Fuse/Relay Block
Fuel Tank Pressure Sensor Top Of Fuel Tank
Idle Air Control (IAC) Valve Top Of Engine, On Throttle Body
Ignition Control Module Right Rear Of Engine, Near Grounding Strap
Intake Air Temperature (IAT) Sensor Left Front Of Engine Compartment, On Air Intake Duct
Knock Sensor Lower Right Of Engine, Below Coil Packs
Manifold Absolute Pressure (MAP) Sensor Top Right Side Of Engine, On Intake Manifold
Post-Converter (Heated) Oxygen Sensor (O2S) Rear Of Catalytic Converter
Powertrain Control Module (PCM) Right Side Of Engine Compartment
Pre-Converter Oxygen Sensor (O2S) In Exhaust Manifold
Throttle Position (TP) Sensor Top Of Engine, Forward Of Throttle Body
Underhood Fuse/Relay Block On Top Of Left Inner Wheelwell
Vehicle Speed Sensor (A/T) Right Rear Of Transmission
Vehicle Speed Sensor (M/T) Left Rear Of Transmission
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.