Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000CHEVY EXPRESS G3500, VAN CARGO EXTENDED, 6.5 FREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - SYSTEM & COMPONENT TESTSIGNITION SYSTEMTIMING CONTROL SYSTEMSKNOCK SENSOR CIRCUIT (MODELS USING KNOCK SENSOR WITH INTERNAL SPARK CONTROLLER MODULE)
2000 Chevrolet Chevy Express G3500, Van Cargo Extended, 6.5 F
Knock Sensor Circuit (Models Using Knock Sensor With Internal Spark Controller Module)
2000 Chevrolet Chevy Express G3500, Van Cargo Extended, 6.5 FSECTION Knock Sensor Circuit (Models Using Knock Sensor With Internal Spark Controller Module)
- An open or short circuit on knock sensor wire to PCM will set a related DTC. A false detonation signal will not cause PCM to set a DTC.
- Install scan tool. Using a metal object, tap on engine next to knock sensor and note knock parameter. Knock should be indicated on scan tool.
- If a scan tool is not available, connect tachometer to engine. Start engine and hold RPM above idle. Using a metal object, tap on engine close to knock sensor. A noticeable decrease in engine RPM should occur. If no RPM decrease occurred, check knock sensor-to-PCM circuit.
- On vehicles equipped with automatic transmission, it may be necessary to place transmission in Drive for timing change to occur.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.