Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000CAVALIER BASE, 4D SEDAN, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 232 (ENGINE CONTROLS - 2.2L (L61) INTRODUCTION)REPAIR INSTRUCTIONSIGNITION CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2000 Chevrolet Cavalier Base, 4D Sedan, 2.4 T
Installation Procedure
2000 Chevrolet Cavalier Base, 4D Sedan, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Make sure the interconnect and seal are lined up before module installation.
- Install the ignition control module in the ignition coil housing.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the ICM retaining screws.
Tighten: Tighten the retaining screws to 1.5 N.m (13 lb in).
- Connect the ICM harness connector.
- Install the accelerator cable bracket.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the accelerator cable bracket bolt.
Tighten: Tighten the retaining screws to 10 N.m (18 lb in).
- Install the accelerator cable to the bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.