Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2000CAVALIER BASE, 4D SEDAN, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 219 (BODY CONTROL SYSTEM)COMPONENT LOCATORBODY CONTROL SYSTEM COMPONENT VIEWS

2000 Chevrolet Cavalier Base, 4D Sedan, 2.4 T

Body Control System Component Views

2000 Chevrolet Cavalier Base, 4D Sedan, 2.4 TSECTION Body Control System Component Views

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Under The Left Side Of The Instrument Panel Component Views

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Data Link Connector (DLC)
2	Brake Pedal
3	Body Control Module (BCM)

Fig 2: Behind The Left Side Of The Instrument Panel Component Views

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Body Control Module (BCM)
2	BCM Connectors
3	G204
4	G201
5	Fuse Block I/P
6	Horn Relay

Fig 3: Left Side Of The Instrument Panel Component Views

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Traction Control Switch Connector
2	Ignition Switch
3	Traction Control/Fog/I/P Dimmer Switch Assembly
4	I/P Dimmer Switch Connector
5	Fog Lamp Switch Connector

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.