Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000CAVALIER BASE, 4D SEDAN, 2.4 TREPAIR AND DIAGNOSIS (SINGLE PAGE)RESTRAINTSAIR BAG, SRSSUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM DEACTIVATION PROCEDURESFORD MOTOR CO.DISABLING & ACTIVATING AIR BAG SYSTEMDISABLING SYSTEM (LS)
2000 Chevrolet Cavalier Base, 4D Sedan, 2.4 T
Disabling System (LS)
2000 Chevrolet Cavalier Base, 4D Sedan, 2.4 TSECTION Disabling System (LS)
- Record radio preset frequencies for reprogramming, if equipped. Disconnect negative battery cable. Wait at least 1 minute for backup power supply to deplete stored energy.
- Remove driver air bag module. See DRIVER AIR BAG MODULE . Connect appropriate air bag simulator to clockspring connector at top of steering column, in place of air bag. See AIR BAG SIMULATOR .
- Remove glove box. Disconnect passenger side air bag module electrical connector. Connect appropriate air bag simulator to vehicle harness, in place of air bag. See AIR BAG SIMULATOR .
- Working beneath driver's seat, disconnect driver side air bag module connector. Connect appropriate air bag simulator to vehicle harness, in place of air bag. See AIR BAG SIMULATOR . Repeat procedure for passenger side air bag module.
- Access driver side seat belt retractor pretensioner in driver side B-pillar. Disconnect driver side pretensioner electrical connector. Attach a seat belt pretensioner simulator to vehicle harness, in place of pretensioner. See AIR BAG SIMULATOR . Repeat procedure for passenger side seat belt pretensioner. Connect negative battery cable.
WARNING:
If vehicle is equipped with side air bags and seat belt pretensioners, manufacturer recommends removing front seats (with side air bag modules) before performing electrical diagnosis on air bag or seat belt pretensioner system. Seats may be left in vehicle if diagnostics are NOT being performed on side air bag or seat belt pretensioner system and simulator tools are installed in place of air bag and pretensioner harness.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.