Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmitter Programming
Tech 2 scan tool must be used to program RKE transmitters. Up to 4 transmitters can programmed to BCM at one time. All transmitters to be used must be programmed in same programming session. Leave a window down during reprogramming procedure. This will prevent unintentional lockout if reprogramming procedure is not performed properly.
- Turn ignition switch to RUN position. Connect Tech 2 scan tool. Following on-screen procedure, enter BCM programming mode. BCM is ready to be programmed when, within 2 seconds:
- Door locks will lock.
- Door locks will unlock.
- Rear compartment lid release will cycle.
- Horn chirp will sound.
- Press and hold LOCK and UNLOCK buttons simultaneously until the following conditions occur in approximately 12 seconds:
- Door locks will lock.
- Door locks will unlock.
- Rear compartment lid release releases
- Horn chirp will sound.
- Repeat previous step for each RKE transmitter.
- Verify proper operation of each transmitter.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.