SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000CAB & CHASSIS K2500, 7.4 J, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 871 (STEERING WHEEL & STEERING COLUMN)REPAIR INSTRUCTIONSSTEERING WHEEL CONTROL SWITCH ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
2000 Chevrolet Cab & Chassis K2500, 7.4 J, Automatic

Removal Procedure

2000 Chevrolet Cab & Chassis K2500, 7.4 J, AutomaticSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering wheel. Refer to STEERING WHEEL REPLACEMENT  .
  2. Remove the shroud retaining screws from the back of the steering wheel.
  3. Remove the shroud from the steering wheel.
    Fig 1: Removing Shroud Retaining Screws From Back Of Steering Wheel
    G01455138Courtesy of GENERAL MOTORS CORP.
  4. Position a blunt ended tool into the wire harness cavity (1) and apply moderate pressure in order to partially remove the steering wheel control switch from the steering wheel.
    Fig 2: Identifying Wiring Harness
    G01455139Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the steering wheel control switch electrical connector.

    Important:  The bulbs in the steering wheel control switches are not serviceable. The switches should be replaced only as an assembly.

  6. Remove the steering wheel control switch from the steering wheel.
    Fig 3: Disconnecting Steering Wheel Control Switch Electrical Connector.
    G01455140Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.