Installation Procedure

2000 Chevrolet Cab & Chassis K2500, 7.4 J, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the console bin and lid assembly over the console in order to route the electrical cord to the console bin.
  2. Install the console bin and lid assembly to the console.

    Important:Β  Ensure the rear bolts has the bigger washer.

  3. Install the 4 console bin retaining bolts (1). Tighten the 4 bolts to 3.5 N.m (35 lb in).

    Important:Β  Ensure the longer, screw is installed in the front of the console bin.

  4. Install the 6 retaining screws (1). Tighten the 6 screws to 1.6 N.m (14 lb in).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.