Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000CAB & CHASSIS K2500, 7.4 J, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 660 (INSTRUMENT PANEL, GAUGES & CONSOLE)REPAIR INSTRUCTIONSCONSOLE TRAY INSERT REPLACEMENTINSTALLATION PROCEDURE
2000 Chevrolet Cab & Chassis K2500, 7.4 J, Automatic
Installation Procedure
2000 Chevrolet Cab & Chassis K2500, 7.4 J, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the electrical connector to the cigar lighter.
- Install the compartment into the IP by sliding forward into the IP.CAUTION: Refer to FASTENER NOTICE .
- Install the compartment to IP fasteners.
Tighten
Tighten the fasteners to 1.4 N.m (12 in lbs).
- Install the console trim plate. Refer to Trim Plate Replacement - Console .
- Install the IP center trim panel. Refer to Trim Panel Replacement - IP Center .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.