Transmission Assembly: Remove, Install, and Overhaul

1999 Chevrolet Tracker 2D Utility, 2.0 C, 4WD, AutomaticSECTION Remove, Install, and Overhaul
WARNING: This page is about the Tracker 2D Utility, 1.6 6, 4WD, which is a different variant/trim than selected.
Applies ToNoteStandard HoursWarranty HoursSkill Level
4WD10.2A
Additional Procedure: TRANSMISSION ASSEMBLY: Remove, Install, and Overhaul:
w/Skid Plate (4x4) add0.40.2A
Combination Procedure: CLUTCH PRESSURE PLATE: Remove & Replace:
0.5C
Combination Procedure: CLUTCH RELEASE BEARING: Remove & Replace:
0.2C
Combination Procedure: FLYWHEEL: Remove & Replace:
0.70.5C
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.