Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999TRACKER 2D UTILITY, 2.0 C, 4WD, AUTOMATICLABOR TIMESOTHER VARIANTDRIVELINES AND AXLESDRIVESHAFTS AND UNIVERSAL JOINTSUNIVERSAL JOINTREMOVE & REPLACE
1999 Chevrolet Tracker 2D Utility, 2.0 C, 4WD, Automatic
Universal Joint: Remove & Replace
1999 Chevrolet Tracker 2D Utility, 2.0 C, 4WD, AutomaticSECTION Remove & Replace
WARNING: This page is about the Tracker 2D Utility, 1.6 6, 4WD, which is a different variant/trim than selected.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Front,Both | 1.4 | B | ||
| Front,One | 1.1 | B | ||
| Rear,One Piece Driveline,(Rear) | 1.4 | B | ||
| Rear,One Piece Driveline,Front | 1.1 | B | ||
| Rear,Two Piece Driveline,One Joint,Front | 0.9 | B | ||
| Rear,Two Piece Driveline,One Joint,Intermediate or Rear | 0.7 | B | ||
| Rear,Two Piece Driveline,Three | 1.3 | B | ||
| Rear,Two Piece Driveline,Two,Front & Intermediate or Rear | 1.1 | B | ||
| Rear,Two Piece Driveline,Two,Intermediate & Rear | 0.9 | B | ||
| Additional Procedure: UNIVERSAL JOINT: Remove & Replace: | ||||
| Where Skid Plate interferes (4x4) add | 0.2 | B | ||
| Combination Procedure: CENTER SUPPORT BEARING: Remove & Replace: | ||||
| Each | 0.3 | 0.3 | B | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.